SW control panel


  • Electronic control panel to drive the A1X24 series DC motors. A microprocessor controls the entire automation, position, slowdowns and obstacle detection via the encoder signal
  • Power supply 100-240 Vac 400 VA 50/60 Hz
  • Output for flashing light 24Vdc 500mA
  • NO + NC programmable relay output
  • PNP NPN inputs for 2 pairs of photocells
  • NPN inputs for open, pedestrian and stop commands
  • Network input for door interlocking
  • Connector for radio receiver
  • Incremental encoder input
  • Serial connector for control and programming push-button panel
  • Connector for connecting batteries and charging module
  • Power cord with Schuko plug
  • RAL7000 plastic container, complete with cable glands and industrial connector for connecting the push-button panel
  • Fixing plate in AISI-304 stainless steel
  • Degree of protection IP65
  • Operating temperature -25 + 70 ° C